Trend

TREND C130 X 1/4 TC CORNER BEAD

Attractive edge moulds, a full corner bead can be produced by making a second pass at 90º. T.C.T. Shank = 1/4in. R = 4.8mm D =... [more]

TREND C041 X 1/4 TC DOVETAIL

These Dovetail Cutters produce a tight reliable joint for drawers, boxes etc. T.C.T. 1/4in Shank. Angle. - 104º Diameter. -... [more]

TREND C149 X 1/4 TC PROFILE SCRIBER

Profile scribed doors in natural timber or medium density fibre board, are traditionally used in cupboards, kitchen doors, drawer fronts and wall... [more]

TREND C150 X 1/4 TC RAISED PANEL

Raised Panel moulder for use in a router table only take 3 or 4 passes at rebated depths. Can be used for curved surfaces if a copy pin is... [more]

TREND C040 X 1/4 TC SELF GUIDED REBATER

This cutter is self guiding and can be used to produce rebates, lapjoints, tongues and rebated corners. Alternative bearings can be purchased to... [more]

TREND C076 X 1/4 TC ROUND OVER 1/4IN

Ovolo & Rounding Over Cutters Ovolo and rounding over cutters without bearing guides are chosen for panel work and edge moulding. Bearing guided... [more]

TREND C116 X 1/4 TC SELF GUIDED TRIM 1/2IN

Self guided trimming bits. Used for trimming plastic or plywood overlays. Also for copy profiling with a template. Raise cutter in stages to... [more]

TREND C115 X 1/4 TC SELF GUIDED TRIM

Self guided trimming bits. Used for trimming plastic or plywood overlays. Also for copy profiling with a template. Raise cutter in stages to... [more]

TREND C145 X 1/4 TC SLOTTING CUTTER 6.3MM

This two wing slotting cutter is ideal for grooving and rebating operations. A 1/2in diameter, bearing is supplied with every cutter. Depth of... [more]

TREND C121 X 1/4 TC TEMPLATE PROFILE 1/4IN

These trimmers with shank mounted bearings are ideal for template guidance. Use for rebating and trimming edges. Extra care must be taken to... [more]

TREND C001 X 1/4 TC TWO FLUTE 3.2MM

Two fluted Tungsten Carbide Tipped straight cutters which are suitable for a wide range of applcations such a engraving, grooving, rebating and... [more]

TREND C002 X 1/4 TC TWO FLUTE 4.0MM

Two fluted Tungsten Carbide Tipped straight cutters which are suitable for a wide range of applcations such a engraving, grooving, rebating and... [more]

TREND C005 X 1/4 TC TWO FLUTE 6.0MM

Two fluted Tungsten Carbide Tipped straight cutters which are suitable for a wide range of applcations such a engraving, grooving, rebating and... [more]

TREND C007 X 1/4 TC TWO FLUTE 6.3MM

Two fluted Tungsten Carbide Tipped straight cutters which are suitable for a wide range of applcations such a engraving, grooving, rebating and... [more]

TREND C008 X 1/4 TC TWO FLUTE 6.3MM

Two fluted Tungsten Carbide Tipped straight cutters which are suitable for a wide range of applcations such a engraving, grooving, rebating and... [more]